For a combined pin housing do the following:

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Pin Housings Released From Each Other

Courtesy of VOLVO CARS OF NORTH AMERICA.

Release the pin housings from each other.

The illustrations (above and below) show pin housings with the contact side up.

Fig 2: Identifying Housing Section Opened To Replace Terminal

Courtesy of VOLVO CARS OF NORTH AMERICA.

Open the housing section to replace terminal

Front housing section

The front housing section opens by carefully bending the secondary locking out and sliding the locking cover forwards 1.5 mm.

Other housing sections

The other housing sections open by pressing in the locking catch on the cable side and sliding the locking cover forwards 1.5 mm.