Test results for the leak diagnostic unit

The parameter displays the result of the diagnostic for the function of the leak diagnostic unit. The diagnostic is run during test phase REFERENCE PHASE 1.

• NO FAULT FOUND = No fault is detected by the control module
• FAULT FOUND, HIGH SIGNAL = Fault in the leak diagnostic unit detected by the control module. This fault status corresponds to diagnostic trouble code (DTC) ECM-431D, signal too high
• FAULT FOUND, LOW SIGNAL = Fault in the leak diagnostic unit detected by the control module. This fault status corresponds to diagnostic trouble code (DTC) ECM-431D, signal too low
• FAULT FOUND, FAULTY SIGNAL = Fault in the leak diagnostic unit detected by the control module. This fault status corresponds to diagnostic trouble code (DTC) ECM-431D, faulty signal
• FAULT FOUND, SIGNAL MISSING = Fault in the leak diagnostic unit detected by the control module. This fault status corresponds to diagnostic trouble code (DTC) ECM-431D, signal missing.