Crankcase ventilation, cleaning: Removing

Remove: 

• battery negative lead. Battery, disconnecting
• the auxiliaries belts. Use 9997109
• the inlet hose for cold air to the control module, if installed.
Fig 1: Power Steering Pump
Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the 3x mounting screws for the power steering pump, through the holes on the pulley.

Fig 2: Identifying Servo And Hoses
Courtesy of VOLVO CARS OF NORTH AMERICA.

Disconnect the power steering hoses and the coolant hoses from their holders/clips.

Remove the tie strap for the servo hose at the spring strut turret.

Remove: 

• the expansion tank for coolant and the power steering reservoir from the mounting on the spring strut turret
• the connector and place the holders on the engine.

Place the power steering pump on the engine.