Checking display function

Fig 1: Identifying Ignition On Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Disconnect the Volvo Scan Tool (ST) from the VIDA station. Use it in stand alone mode and connect it to the data link connector (DLC) in the car.
• Ignition on.
• Use the function Activation to activate the display. For further information about Activation, see Activating components/functions .

  Check that the display picture and color are OK.

  Fig 2: Identifying Scan Tool

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Are the display picture and color OK? 

• YES 

  Refer to Intermittent fault 

• NO 

  Refer to Replacing control module