Internal fault: Verification

HINT: After the repair it is necessary to check that the fault has been rectified: 

Fig 1: Identifying Ignition On Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connectors

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Connecting Control Unit

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off.
• Connect the connectors, install the components etc.
• Ignition on.
• Use the System test functions to test the control unit's circuits (GPS). The test can take up to approximately 40 seconds. For more information about System test, see System Test .

  Check that the control unit is OK.

  If the control unit is working, OK is displayed.

  Fig 4: Identifying VCT2000

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Is the control unit OK? 

• YES 

  OKAY:  Troubleshooting has been completed.

• NO 

  Refer to Information