Activating lamps

Fig 1: Identifying Ignition On Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition on.

  Check whether the relevant lamp lights when the ignition is switched on.

  Activate the system test procedures and check whether the relevant needle or lamp operates correctly. All needles should move from minimum to maximum and back again, and lamps should flash (except for the MIL). All segments in the display screen flash.

  Remedy as necessary.

  Other information: 

  • To replace the lamps, see Replacing bulb .
  • To replace the gauge, see Replacing tachometer, temperature gauge, fuel gauge and speedometer .
  Fig 2: Identifying VCT2000

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Select "Continue" when the fault has been remedied. 

• Continue 

  OKAY:  Troubleshooting has been completed.