Removing clutch cable
Fig 1: Identifying Clutch Line, Quick-Release Connector, Ground Lead And Clamps For Engine Cable Harness
Clamp the hose between the brake fluid reservoir and the clutch master cylinder. Use hose pliers.
Remove the clutch line from the adapter: Pull out the locking tongue which locks the quick-release connector to the adapter.
Remove the quick-release connector from the adapter.
Wipe up any brake fluid that leaks out.
Reinstall the locking tongue in the adapter.
Protect the ends of the clutch cable with a plastic bag.
Lift the pipe out of holder on the side of the transmission. Place it to one side.
Remove the ground lead from the transmission.
Remove the clamps for the engine cable harness.