Removing screws for sub-frame

Fig 1: Identifying Screws For Sub-Frame Support Brackets

Courtesy of VOLVO CARS OF NORTH AMERICA.

Position mobile jack 9985972 in light contact under the left-hand side of the sub-frame as support.

Remove the screws securing the sub-frame support brackets on the left and right-hand sides.

Slacken off the two screws for the sub-frame mounting in the bodywork on the right-hand side by approximately 15 mm  .Note! All-wheel drive (AWD) = maximum 5 turns  .

Remove the screws on the left-hand side.