Replacing rear camshaft seal: Finishing

Fig 1: Identifying Under-Hood View

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install 

• The trigger wheel.

  Tighten to 17 Nm  (12.54 lb.ft).

• Camshaft position sensor housing and a new cover.

  Tighten screws.

• The torque rod bracket.

  Tighten to 50 Nm  (36.9 lb.ft).

• Torque rod.

  Tighten to 35 Nm  (25.82 lb.ft) and angle tighten 90 degrees  .

• Ignition coils cover.

  Tighten to 8 Nm  (5.9 lb.ft).

• The air cleaner (ACL) cover and air intake hose to intake.