Raising the rear suspension
WARNING: This page is about a different variant/trim than selected.
Raise the rear suspension with fuel tank.
Make sure the filler pipe does not foul the wheel arch liner. Make sure the fuel line is clear of the body and that the fuel gauge line does not get caught in the fuel strap brackets.
Lift up the tank fitting lines and fuel pump lines through the body (hatch).
CAUTION:
Secure the front part of the differential to the lift table. This prevents the rear suspension from tipping backward when lifted.
NOTE:
Check also that the fuel line between the fuel level sensor and the ejector pump does not foul the body when the rear suspension is lifted.
Adjust and secure the filler pipe's crash guard bracket.