LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2003 >> C70 2.3 53, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine With Mountings And Equipment- Fuel System (Convertible)) >> Changing the fuel tank, AWD >> Fuel tank, replacing >> Changing the fuel tank >> Fitting the rear suspension assembly >> Fitting the retaining bolts for the rear axle member

Fitting the retaining bolts for the rear axle member

WARNING: This page is about a different variant/trim than selected.
Fig 1: Rear Axle Member Guide
GLL109995Courtesy of VOLVO CARS OF NORTH AMERICA.

Apply a couple of drops of threadlock, part number 1161351-0, to each bolt.

Fit all the retaining bolts for the rear axle member.

NOTE:

Before fitting the rear axle to the body, measure the distance between the rear axle member guide ø 16.5 mm holes (A) outside the rear retaining bolts, and the ø 16 mm holes furthest to the rear on the side members. The distance between the holes should be 595 mm +/- 2 mm.

Tighten the outer bolts to 80 Nm  and the center bolts to 50 Nm  .

scientia non olet · About LEMON Manuals