Fitting the propeller shaft and driver

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Propeller Shaft And Special Tool (Holder) 9995561

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fit the propeller shaft to the driver.

NOTE:

Fit the propeller shaft as marked earlier. Refit the bolts in their original positions.

Check that the contact surfaces of the viscous coupling and propeller shaft driver are clean.

Tighten opposite bolts to 8 Nm . Then tighten opposite bolts to 30 Nm . Use holder 9995561 . Start by tightening the same bolt both times.