Fitting the longitudinal stay mountings and jack attachments

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Link Arms And Tensioner 999 5659

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fit the front longitudinal stay mountings and the jack attachments to the body.

Press up the link arms to their normal position.

See XXX (tension yoke) and XXX (normal position).

Connect the LH three-way branching to the LH jack attachment.

Fit the longitudinal stay brackets and the jack attachments using new bolts.

Tighten the 3 bolts for the longitudinal stay bracket to 65 Nm + 60° .

Tighten the bolt through the jack attachment to 105 Nm + 90° .