Removing And Installing Stub Axle: Remove

Raise the car.

Fig 1: ABS Line And Anti-Roll Bar Link From The Spring Strut

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove 

• the wheel
• the anti-roll bar link from the spring strut. Use a fixed wrench as a counterhold
• the ABS sensor. Hang up sensor with a piece of wire
• ABS sensor cable from spring strut

Fig 2: Brake Caliper And Limiter Mounting Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

• brake caliper and limiter mounting screws
• the limiter. Hang caliper up with a piece of wire.

Fig 3: Slackening Drive Shaft Hub

Courtesy of VOLVO CARS OF NORTH AMERICA.

• drive shaft screw. Use a screwdriver as counterhold on the brake disc
• locating pin holding brake disc
• brake disc.

Slacken off end of the drive shaft in the hub by knocking the drive shaft into the hub approximately 10-15 mm  . Use a rubber or copper mallet.

Fig 4: Removing Tie Rod Ends From Steering Arm Using Puller 999 5259

Courtesy of VOLVO CARS OF NORTH AMERICA.

• tie rod ends from the steering arm. Use puller 9995259 .

Fig 5: Identifying Screws Retaining Spring Strut In Stub Axle

Courtesy of VOLVO CARS OF NORTH AMERICA.

• both screws retaining the spring strut in the stub axle.

Fig 6: Drive Shaft Hanging From Hook 999 5045

Courtesy of VOLVO CARS OF NORTH AMERICA.

Prize out the stub axle.

Pull out the drive shaft and fold to one side. Hang up drive shaft on a hook 9995045 .

Fig 7: Removing/Installing Nut On Ball Joint

Courtesy of VOLVO CARS OF NORTH AMERICA.

• nut on ball joint. Use a Torx wrench as counterhold
• stub axle.