Wastegate valve, adjusting: Reinstall
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Install the split pin on the lever.
Tighten the lock-nut on the push rod.
Remove the test equipment.
Connect the hose.
Install the heat shield.
Erase any diagnostic trouble codes (DTCs).
Test drive the car. Accelerate to wide open throttle (WOT) a couple of times.
Then check that no diagnostic trouble codes (DTCs) have been stored.