Replacing the rear camshaft seal

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Special Tool Extractor 9995919

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove and replace the seal:

Carefully pull out the old seal.

Use extractor 9995919 .

Fig 1: Identifying Rear Camshaft Seal

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install new seals:

Grease and install the new seal.

Use drift 9995450 .

NOTE:

The seal is normally pressed in so that it is level with the internal beveled edge.

If the shaft journal is showing signs of wear, the seal can be pressed in 2 mm (0.079 in) deeper by turning the drift socket.