Reinstall camshaft components and covers

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Camshaft Components

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the trigger wheel.
Tighten to 17 Nm (12 lb.ft.) .
the camshaft position (CMP) sensor housing and a new cover.
Tighten to 10 Nm (7.4 lb.ft.) .
the torque rod bracket.
Tighten to 50 Nm (37 lb.ft.) .
the upper torque rod.
Tighten to 35 Nm (26 lb.ft.) . Angle-tighten 90 degrees .

Use bevel protractor: 9512050
the cover over the ignition coils.
Tighten to 8 Nm (6 lb.ft.) .
the charge air pipe over the engine.
Remove the seals.
the air cleaner (ACL) cover and the intake air hose.
the solenoid valves on the air cleaner (ACL) cover.
connect the battery negative terminal. Battery, disconnecting .

Check the engine compartment and wipe it clean.