Remove and install new seal
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Carefully pry out the seal with a groove-cut chisel.
Clean seal seats and check for shaft end grooving.
Grease the seal.
Install the new seal by pressing it in with drift 9995450 .
NOTE:
The seal is usually positioned flush with the inner chamfer edge. If the shaft journal is showing signs of wear, the seal can be pressed in 2 mm deeper by turning the drift socket.