Checking 15-supply from ignition switch

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Ignition Switch ON Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition off.
Disconnect the connector from the ignition switch.
Turn ignition switch to II.

Fig 2: Identifying Connector From Ignition Switch
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Ohmmeter
Courtesy of VOLVO CARS OF NORTH AMERICA.
- First connect an ohmmeter between ignition switch terminals 15 and 30 and then between ignition switch terminal 15 and the other ignition switch terminal 30

In both cases the ohmmeter should read 0 Ω.

OK
Refer to Checking voltage to ignition switch
NOT OK
Refer to Replacing ignition switch