Removing components
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Remove:
- battery negative terminal.
- plastic hoses turbocharger (TC)/charge air cooler (CAC) and air cleaner (ACL)/turbocharger (TC)
Remove the clamp to intake manifold at turbocharger (TC) 1, 2, 3 and turn the pipe upper section to the firewall.
(Only B6284 T)
- plastic pipe over engine.
(Only B52X4 T)
- cross member.
- right front wheel.
- plastic nuts for cover in fender liner.
- camshaft position sensor (CMP) housing and trigger wheel.
- camshaft rear edge cover.
- upper camshaft belt cover.
Lift up servo reservoir, place over engine.
NOTE:
Ensure that the oil does not run out of the ventilation hole in the filler cap.
Remove:
- hose between expansion tank and water cooler by the reservoir. Seal the hose with lock grip pliers.
- auxiliaries belt.
- front camshaft belt cover.
- Continue