Connecting the breakout box

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

The voltage supply to the control module must be disconnected when disconnecting the breakout box. Failure to observe this procedure could seriously damage the control module.

Fig 1: Identifying Ignition OFF

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Disconnecting Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

For more help with connection see Measuring instruments .
Ignition off
Disconnect the transmission control module (TCM).
Connect adapter 9511504 to transmission control module (TCM) connector and connect breakout box 9511428 to the adapter.
NOTE:
Ensure that the adapter is the right way round - with the breakout box cable harness outwards towards the fender.

Fig 3: Identifying Breakout Box
Courtesy of VOLVO CARS OF NORTH AMERICA.

Continue
Refer to Checking ground terminals