Connecting breakout box to immobilizer connector (A)

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Connection Between Breakout Box, Connector A, And Immobilizer

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition off
Remove the control module from the bracket. See Replacing immobilizer control module
Disconnect the connector (A) from the control module.

Connect one of the 10-pin connectors on adapter 9813194 to the connector (A). Connect breakout box 9813190 to the adapter.

For further information about signals and other values, see Immobilizer signal specification .