Removing the EVAP Canister

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying EVAP Canister

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Clamp Being Squeezed By Pipe Wrench

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove:

connector/outlet. Press in the catch and pull
Removing the clamp on the air from the EVAP canister shut-off valve:
- squeeze the clamp with a pipe wrench. Hold in place
- pry apart with a small screwdriver.
connector/inlet. Press in the catch and pull
Removing the clamp on the air from the EVAP canister shut-off valve:
- squeeze the clamp with a pipe wrench. Hold in place
- pry apart with a small screwdriver.
outlet hose from the EVAP canister bracket.
Removing the clamp on the air from the EVAP canister shut-off valve:
- squeeze the clamp with a pipe wrench. Hold in place
- pry apart with a small screwdriver.
air hose from the EVAP canister shut-off valve
rubber mounting with the EVAP canister shut-off valve from the EVAP canister bracket
front and rear screw (2).

Remove:

the nut on the bracket at the fuel filter.

Fig 3: Identifying EVAP Canister With Bracket

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove:

the EVAP canister with its bracket
Slacken off the screw on the underside of the bracket (Torx 25).
the EVAP canister from the bracket.