Removing the EVAP Canister Shut-Off Valve

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying EVAP Canister Shut-Off Valve

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Clamp Being Squeezed By Pipe Wrench

Courtesy of VOLVO CARS OF NORTH AMERICA.

Disconnect the connector
Removing the clamp:
- squeeze the clamp with a pipe wrench. Hold in place
- pry apart with a small screwdriver.
  NOTE: These are reusable.
Remove the clamps (2) at the EVAP canister and rear axle joint, and one tie strap.
Removing the clamp:
- squeeze the clamp with a pipe wrench. Hold in place
- pry apart with a small screwdriver.
  NOTE: These are reusable.
Disconnect hoses.
Remove the rubber mounting from the bracket.