Routing the Wiring Harness

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying String Attached To Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Loosen and separate the connector for the fuel level sensor.

Bend the fuel level sensor's wiring harness over to the right-hand side.

Attach a length of string or the like to the connector for the fuel level sensor. See illustration.

Carefully pull the wiring harness and connector through the fuel level sensor's hole.

NOTE: Leave the string in place so that the connector for the new fuel level sensor can be pulled back.

Fig 1: Identifying String Attached From Wiring Harness To Fuel Level Sensor

Courtesy of VOLVO CARS OF NORTH AMERICA.

Attach the string from the wiring harness to the new fuel level sensor.

Carefully pull the fuel level sensor's wiring harness back into position.

Fig 2: Identifying Fuel Lever Sensor's Wiring Harness

Courtesy of VOLVO CARS OF NORTH AMERICA.

Check that the fuel level sensor's wiring harness has returned to the left-hand side of the vehicle.

Reassemble the connector and fit it back in the holder.