Removing front suspension components (both sides)
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Remove:
- the soundproofing over the drive shaft (applies to certain versions)
- the screw for the drive shaft. Counterhold using a screwdriver in the brake disc vents. Tap in the end of the drive shaft approximately 20 mm
- the link from the anti-roll bar. Counterhold using a Torx wrench in the ball joint pinion to prevent the boot from turning
- the nut for the ball joint / link arm. Clean the exposed threads outside the nut. Spray using rust solvent before removing the nut.