Disconnecting the ball joint pinion from the control arm (both sides)
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Use tool 9997062 . Install cap nut 7062-1 on the ball joint pinion. Tighten the nut to the control arm. Then slacken off 1 to 2 turns so that there is clearance between the cap nut and the control arm.
Position puller 9997062 on the control arm and detach the ball joint from the control arm.
Remove the tools.