Removing the Drive Shaft From the Hub

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Pulling Out Spring Strut And Removing Drive Shaft From Hub

Courtesy of VOLVO CARS OF NORTH AMERICA.

Pull out the spring strut and remove the drive shaft from the hub. Hold the spring strut to one side using a tensioning strap for more space when removing the drive shaft.

Fig 2: Identifying Rubber Seal On Constant Velocity Joint

Courtesy of VOLVO CARS OF NORTH AMERICA.

CAUTION: Later models have a rubber seal on the constant velocity joint. Do not damage the seal. It will be needed for installation.

Fig 3: Removing Left Drive Shaft From Gearbox Using Jimmy Bar

Courtesy of VOLVO CARS OF NORTH AMERICA.

Use jimmy tool when removing the drive shaft.

NOTE: Pull the constant velocity joint , not the drive shaft joints, when removing the drive shaft. There is no axial pinion.

NOTE: Take care not to damage the drive shaft when removing it from the transmission.

Install sealing plug in the transmission.