Installing the nuts securing the ball joint to the control arm and the anti-roll bar to the link rods

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Ball Joint Nut

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the nuts for the ball joint and control arm: Counterhold with a Torx spanner so that the boot does not rotate. Tighten to 80 Nm .

Install the anti-roll bar and link rods: Use new nuts. Tighten to 50 Nm.