Remove the Drive Shaft From the Transmission
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Blow clean thoroughly around the drive shaft.
Remove the cover from the drive shaft pilot bearing.
Remove the drive shaft by pulling it straight out from the transmission. Do not pull on the outer constant velocity joint housing.
NOTE:
Do not damage the seal.
Wipe up any spilled oil.