Bond the Drive Shaft And Hub

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Holder 9995563

Courtesy of VOLVO CARS OF NORTH AMERICA.

Apply metallic adhesive 1161370-0 on the drive shaft splines for the hub as illustrated.
Use holder 9995563 to hold the control arm down.
Fold out and turn the spring strut and locate the drive shaft in the hub.
Fit the drive shaft nut manually.
The old nut can be used again. Oil the nut.
Remove the holder.

NOTE: Take care not to damage the drive shaft boot.