Installing the left hand drive shaft to the transmission, wheel spindle and link arm

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Wheel Spindle On Control Arm

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE: Take care not to damage the drive shaft seal in the transmission.

Press in the drive shaft so that the snap ring locates in the groove. Pull the constant velocity joint to check that the drive shaft is secure.

Install the wheel spindle on the control arm.

Install the lock nut loosely.