Installing the right drive shaft on the transmission, wheel spindle and control arm

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Drive Shaft At Transmission

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE: Take care not to damage the drive shaft seal in the transmission.

Install the drive shaft pilot bearing cover

Tighten with 25 Nm .

Align the drive shaft in the wheel arch. Install a new screw loosely in the drive shaft.

Install:

the mobile jack under the sub-frame. Remove both the sub-frame screws. Lower the sub-frame approximately 10 cm
the wheel spindle on the control arm
the lock nut loosely.

Lift the sub-frame to the bodywork. Install the frame screws.

Press the evaporator cable and the oil pipe into place in the sub-frame clips.