Installing the throttle body (TB)

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Install

a new throttle body (TB) with a new gasket . Tighten to 10 Nm
Connect the throttle body (TB) connector
the tie strap at the connector
the pipe between the throttle body (TB) and the charge air cooler (CAC)
the intake manifold between the front cover plate and the air cleaner (ACL) housing
the battery negative lead. Battery, disconnecting .

NOTE:

After replacing the throttle unit, the throttle unit must be adapted using the vehicle communication input: "Adaptation of the electronic throttle unit".

Remedy as necessary.