RH Drive Cars Only

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Impact Absorber Bolts

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove impact absorber over steering gear. (2 bolts.)

Fig 1: Identifying Subframe

Courtesy of VOLVO CARS OF NORTH AMERICA.

Lower subframe approximately 100 mm.

Check that the five steering gear bolts and crash guard bolts come away from frame.

Remove anti-roll bar bearing cap bolts (left-hand side). Undo bolts on right-hand side until they are only held by a few turns.

Lash anti-roll bar to steering gear as shown in picture.