Rear Wheel Hub, Replacing: Removal

Removing rear wheels 

Remove the rear wheel.

Removing the brake calliper and brake disc 

Remove: 

• the wheel sensor cable from the retainer on the brake hose
• the brake calliper mounting screws.

  Suspend the calliper in a steel wire.

• the brake disc locating pin/screw
• the brake disc.

Removing the wheel sensor 

Clean the area around the wheel sensor and remove the screw.

Carefully remove the sensor from the wheel spindle.

Bind the sensor so it is well protected.

Installing the tensioner 

Install 9995659 . See Tensioner 999 5659, User instructions .

Support the rear suspension 500 mm up between the fender edge and the center of the wheel.

Removing the hub 

Remove: 

• the 4 screws
• the hub.