Installing The Rear Axle
- Raise the rear suspension 50 mm to the installation position
- Install the three hoses on the EVAP canister
- Carefully raise the rear suspension.
Does not apply to AWD:
Install the two screws for the spring seat mounting. Tighten to 50 Nm .
WARNING:
Always check that the car does not lift from the lifting arms of the car lift when working with the lifting table.
NOTE:
Do not tighten the screw for the bushing mountings. This is carried out later when the rear suspension is in the normal position.
NOTE:
Guide in the propeller shaft when lifting operation.
NOTE:
Ensure that the brake pipes or cable harnesses are not trapped.