Removing the throttle body

Fig 1: Identifying Charge Air Pipe With Hose Clamp

Courtesy of VOLVO CARS OF NORTH AMERICA.

Slacken off the hose clamp for the charge air pipe on the throttle body (TB).

Remove the charge air pipe from the throttle body.

Fig 2: Identifying Cylinder Block Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

If the wiring to the throttle body is behind the bracket for the starter motor:

Slacken off the nuts (x 2).

Remove the screw.

Remove any tie straps and disconnect the connector for the throttle body.

Route the wiring for the throttle body from the reverse of the bracket for the starter motor.