Installing the throttle body

Fig 1: Identifying Throttle Body And Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

Fig 2: Identifying Cylinder Block Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Position the wiring for the throttle body behind the bracket for the starter motor.

Install the screws in the cylinder block.

Tighten the 2 x nuts and the screws.

Connect the connector and install the tie strap.

NOTE:

If the wiring was not behind the bracket for the starter motor, it must be secured along the cable duct by two tie straps.

Raise the car.

Remove the splash guard under the engine.

Tighten the 4 x screws for the throttle body.

Lower the car.

Fig 3: Identifying Charge Air Pipe With Hose Clamp

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the charge air hose to the throttle body and tighten the clamp.