PUR on body flange

• After the window has been removed, the surplus PUR glue on the body flange must be removed using H cleaner.

• If the surface is uneven, a chisel with width approximately 13 mm / 0.5 in  may be used to even out the remaining PUR bead.
• Do not touch the PUR bead with your hands. Grease on PUR can cause adhesion problems. 

Plate work 

• If some of the window frames have been painted, the body flange must be coated with paint primer (Component number 1161386).
• If 2-component glue is used, the window must be in place within 10 minutes  .
• Ensure that the bead is continuous without break, otherwise the joint will not be tightly sealed which will result in water leakage.
• Always open a side window when replacing a window, otherwise the window may fall out of position when the door is closed.
• Read.