Installing front bumper

Fig 1: Identifying Lugs Alignment On Bumper In Channels On Slide Mounting

Courtesy of VOLVO CARS OF NORTH AMERICA.

Align the lugs (3) on the bumper in the channels (4) on the slide mounting. Press at the top so that the lugs secure.

Press in the bumper cover as far as it will go.

Install the 2 M8 screws. Tighten.

HINT: This operation is easier with two people. 

Fig 2: Identifying Screw Pressed Backwards To Release Bumper Bracket

Courtesy of VOLVO CARS OF NORTH AMERICA.

Tighten the 2 screws for the sliding mounts. Ensure that the slide mountings engage the bumper cover.

Install: 

• the 6 clips, on the upper side of the casing
• the connectors for the fog lamps
• the two clips on the underside of the bumper
• the left and the right trim strip.