Checking components and wiring
Check that shunt 20/29 is not damaged. The resistance between the terminal pins is 0 ohm to 5 ohms depending on which pin the reading is taken at.
Check the cable between relay 2/83 terminal #3 and the left and right lower lamp housing connector terminal #3A. Check for an open-circuit according to Open-circuit, permanent faults . Check for a short-circuit to ground according to Short-circuit to ground, permanent faults .
Check the cable between the left and right upper lamp housing connector terminal #4A and the ground terminal for an open-circuit according to Open-circuit, permanent faults .
Check that fuse 11D/2 is intact.
Remedy as necessary.
Other information:
- For further information about signals and other values, see Signal specification
- To connect the breakout box, see Connecting the breakout box .
- To access the integrated relay / fusebox in the cargo compartment, see Relay/fuse box cargo compartment/Rear electronic module (REM), replacing .
Was a fault detected?
- YES
OKAY: Troubleshooting has been completed.
- NO
FAULT NOT FOUND: Troubleshooting has been completed.