Remove and reinstall cables
Courtesy of VOLVO CARS OF NORTH AMERICA.
- Remove the wiring from the connector. Insert a pointed object in the space under the relevant cable terminal. Press together the sprung catch. At the same time, pull the cable out
- Remove the black (SB) cable from terminal 6
- Cut off the cable terminal. Twin the cable terminal with the black (SB) cable which goes to the control module
- Install a new cable terminal, (P/N 9168510). Connect the new cable terminal to terminal 6 in the connector
- Remove the blue (BL) cable from terminal 4
- Cut off the cable terminal
- Take the switch from the kit. Twin one of the cables with the blue (BL) cable
- Install a new cable terminal (P/N 9168510). Connect the new cable terminal to terminal 4 in the connector
- Reinstall the orange catch on the connector. Press the catch into place
- Install a cable connector (1) between the red (R) cable from the switch and the red (R) cable from the control module. Connect these together
- Reinstall the connector in the tail lamp.