Windshield washer fluid reservoir, replacing: Removal

Fig 1: Identifying Windshield Washer Reservoir

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Remove the filter cover on the control module box
  • Yellow valve = front windshield washer
  • White valve = rear windshield washer.
• Remove the filler pipe. See Filler pipe for the windshield washer reservoir
  • Yellow valve = front windshield washer
  • White valve = rear windshield washer.
• Separate the hoses at the filler pipe:
  • Yellow valve = front windshield washer
  • White valve = rear windshield washer.

Fig 2: Identifying Bumper Cover Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Remove the soft nose on the right-hand side. See Casing .

• Remove the screws for the soft nose guide. See Casing
• Disconnect the connector under the reservoir
• Remove the screws from the reservoir
• Carefully tension out the soft nose. Release and pull out the reservoir slightly
• Remove the air intake pipe for the control module box from the mounting on the reservoir
• Take down the reservoir.