Installing the steering wheel

Fig 1: Horn Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Position the contact reel connector between the two lugs (D) on the contact reel.

Route the wiring for the contact reel through the hole in the steering wheel.

Install:

Connect the connector (C) for the horn.

Install the driver's airbag (SRS). See:Airbag driver's side (SRS), replacing .

Fig 2: Ignition On, Battery Connected And Radio Code

Courtesy of VOLVO CARS OF NORTH AMERICA.

WARNING:

Ensure that nobody is in the car when the battery is connected.

Switch ignition to position II.

Connect the battery negative lead.

Enter the anti-theft radio code.

Set the car clock to the correct time.

Check the function of the horn.

Check that the SRS (supplemental restraint system) indicator lamp lights and goes out after approximately ten seconds.