Checking the EVAP canister purge valve
HINT: Leakage through the EVAP canister purge valve can be checked by blocking the hose between the EVAP canister and the purge valve and then running the quick test of the fuel tank system. If leakage was detected in a previous quick test of the fuel tank system but is not now detected when the hose between the EVAP canister and the purge valve is blocked, the leakage may be through the EVAP canister purge valve.
- Disconnect the hose between the EVAP canister purge valve and the EVAP canister from the connection to the EVAP canister purge valve. Block the hose while running the quick test of the fuel tank system.
Other information:
- For the location of components on 5 cylinder engines, see Location of components
- Location of components, 6 cylinder turbocharged engines:
- For 6 cylinder turbocharged engines -2001, see Location of components
- For 6 cylinder turbocharged engines 2002, see Location of components, engine compartment
- For 6 cylinder turbocharged engines 2003-, see Location of components, engine compartment .
Carry out the quick test of the fuel tank system
- Continue