Installing the right-hand drive shaft to the gearbox, wheel spindle and link arm

Fig 1: Identifying Bearing Cap And Drive Shaft Support Bearing

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the drive shaft and the cap for the pilot bearing. Use 2 x M8 screws. Tighten.

Lubricate the drive shaft splines. Use a small amount of thin oil.

Locate the drive shaft in the wheel hub. Install a new screw loosely in the drive shaft. Press down the control arm. Locate the spring strut in the ball joint pinion for the spring strut in the control arm.