Fitting the torque converter screws.

Fig 1: Identifying Torque Converter Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE:

Use new screws, Torx TX50.

Align the torque converter to the carrier plate, by turning the engine with the nut to the crankshaft pulley and turning the torque converter.

Fit all screws, 6, loosely. Insert the screws as far as the screw heads sit against the carrier plate. Tighten in accordance with: Summary of tightening torques for specific components .

NOTE:

Remove the socket wrench from the crankshaft.