Removing the gearbox mounting screws

Fig 1: Identifying Bracket

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the bracket with the connectors for the heated oxygen sensors (HO2S) and the clamp for the cable harness from the gearbox.

Remove: 

• the screws for the clamp securing the cable harness at the rear edge of the engine
• the nut, 1, for the bracket to the cable harness and the coolant hose
• the bracket for the air cleaner (ACL) (only applies to B5254T4)
• the 3 screws for the gearbox and engine and the 2 screws for the starter motor.

Tie up the cable harness.