Low Stalling Speed

The test conditions described in Check  above have been met.

Try a new torque converter if the stall speed recorded is below the normal value by more than 300 RPM. 

See Gearbox, Removing and Installing The Gearbox .

Check the stalling speed again after replacing the torque converter 

Replace the transmission if the fault persists. See Gearbox, Removing and Installing The Gearbox .

After the check is completed: 

Ignition off.

Remove both the manometer connection and the manometer.

Install: 

• the test plug. Check that the O-ring is undamaged. Replace if necessary. Tighten. See Summary Of Tightening Torques For Specific Components .
• the bracket for the side member
• the holder for the connectors on the bracket
• the cover for the bracket.